Sarah F.

I found the inducer motor had failed. I informed the customer of my findings and told them that we would have to replace the motor just to see if anything else was wrong with the furnace. I talked over repair and replace options with the customer and they opted to install a new furnace. System is not operational upon departure.

Noah B.

I performed a diagnostic and found inducer bearing failure. I suggested to replace the part or the furnace.

Hunter P.

I recommended the customer look into having a company come out to clean the furnace, along with the ducts. I also noticed the blower motor specifically needed to be pulled and cleaned. I quoted cleaning prices we could do to the customer for them to decide.

Bella M.

After performing diagnostic tests on the Bryant gas furnace, I could still not determine the issue. I will return with my supervisor to dig into the furnace to determine the issue.

Bella M.

I replaced the gas valve, recycled the system and everything is operational.

Justina P.

I replaced out of warranty part direct drive blower motor w capacitor. Any defects found after repairs are completed are not included.

Noah B.

I replaced OEM direct drive blower motor with capacitor.

Justina P.

I replaced OEM direct drive blower motor with capacitor.

Noah B.

I ran diagnostic on system found blower bearing failure. Gave customer options. Customer opted to repair.

Noah B.

I cleaned the flame sensor, replaced motor surge capacitor 1-7.5MSC and replaced ignitor- Carrier, Bryant (W Shaped) on a 2004 Rheem gas furnace.